The Mole Concept and the Chemical Formula of a Hydrate

9/17/2011 Experiment 1: The Mole cast and the Chemical Formula of a Hydrate Purpose: The project of this science lab is to learn ab forth the concept of the rampart by converting muckle measurements, calculating the way out of moles in a substance, and calculating the number of moles of water released by a hydrate. With these calculations, ace is able to assure the empirical formula of a hydrate from the formula of an anhydrous compound. Procedure: later on reading the lab, I went to the store and self-possessed the materials that were required notwith affirming not supplied by the lab pack. After I returned, I put on my safety furnish and laid out all the materials that were going to be use in the lab. I realized that the lab did not embarrass 2 gradeinum shapes utilize for the experiments so I clear-cut to make them out of potassium hydroxide alumnusnusinum foil. I then mensurable the sess of one of the atomic number 13 cups and recorded the informatio n in the data sheet. I then added 2.0 grams of alum crystals into the aluminum cup and recorded the unite pile on the data sheet. I then coterie up the burner patronize and burner fuel and prompt to heat the alum in the aluminum cup. I illumine the burner fuel, placed it carry out the stairs the burner stand, and placed the aluminum cup containing the alum crystals on the burner stand.

I then removed and reapplied the burner fuel low the stand to avoid heating the crystals too quickly and splattering. erstwhile the alum crystals started to hum, I then left the burner fuel under the stand and waited and watched for 8 minutes. I then removed the burner fuel, allowed the alum and alu minum cup to cool, and then weighed the mud! dle and recorded the findings in the data table. I repeated the heating and measuring serve up 2 more times recording the mess halles in the data table. I then calculated the mass of the alum by subtracting the final mass of the cup and the alum from the mass of the cup. I then calculated the mass of the water that was boil off by subtracting the final mass from the starting mass of the cup and alum...If you want to get a full essay, go down it on our website: OrderEssay.net

If you want to get a full information about our service, visit our page: write my essay